Water Heater Repair & Installation · Oceanside · ZIP 11572
Water Heater Repair & Installation in Oceanside, NYOut of the Floodwater
All Island Plumbing NY repairs and replaces gas and electric tank water heaters in Oceanside (ZIP 11572), Harbor Isle and Point Lookout, Town of Hempstead. Call (516) 360-9493. We answer calls 24/7 and are open Monday through Saturday (closed Sunday).
Smell gas? Leave the house first, then call the gas utility's emergency line or 911.
Call for service
Tap the button to call from your phone.
Call (516) 360-9493Online requests are coming soon. For now, calling is the fastest way to reach us.
- Serving Nassau County and western Suffolk County, Long Island, NY
- Licensed & insured across Long Island
- Answering calls 24/7 · Open Mon–Sat, closed Sunday
In much of Oceanside the water heater sits in a basement or utility room that is in FEMA's high-risk flood zone. That, more than anything, decides how heaters fail here. See also our Oceanside page and water heater repair and installation.
Where the heater sits
Our overlay of FEMA's flood map puts about half of the Census Bureau's Oceanside area in the high-risk zone. A heater that has been under water usually has to be replaced: water gets into the burner, gas valve, controls and insulation. After a flood, keep it off until it's checked. When we install a new one on a flood-prone street, we look at raising it on a stand or moving it to a higher spot, as far as the gas line, venting and space allow.
The water it heats
Oceanside is on Liberty Utilities' Lynbrook system. Liberty's 2026 report on 2025 water lists hardness of only 4.2 to 58.6 mg/L, and a Langelier corrosivity index that is negative across its range (-6.28 to -0.19), meaning the water leans corrosive rather than scale-forming. Liberty raises the pH with caustic soda or lime to protect pipes. For a tank, the practical result is a hard-working anode rod; once it's spent, the steel starts to rust. An older tank with rusty hot water may need a new anode or a replacement.
Iron in the bottom of the tank
The same report explains that the state lets the Lynbrook district carry up to 1,500 parts per billion of iron because it treats with sodium silicate, which keeps iron dissolved. Some of it drops out when water is heated. A yearly flush clears it before it builds into a layer that rumbles and cuts capacity.
Gas, mostly
The Census Bureau's latest survey shows 67% of homes heating with gas, 22% with oil and 8% with electricity, so most heaters here are gas tanks venting into a chimney or flue. A replacement has to vent properly, have a working gas shutoff and a relief valve that discharges where it should. In oil-heated houses, hot water may come from the boiler; converting to gas usually adds a separate gas water heater and gas piping. We do the heater and the gas line, not oil boilers.
Sized to the house
The survey puts the average owner household at 2.89 people, with 39% of homes having four or more bedrooms. A household that size is usually well served by a standard tank, unless the house has gained bathrooms. We size the replacement to the people and the bathrooms, not to the old label.
More
More for Oceanside and nearby
Water heaters in nearby towns
Questions
Water heaters in Oceanside: FAQ
Our water heater was replaced after Sandy. Is it near the end?
Can we raise our water heater above flood level?
Why does our hot water smell or look rusty?
Sources:FEMA National Flood Hazard Layer overlaid on the Census 2020 Oceanside CDP boundary (Atlas, Nov. 5, 2026); Liberty Utilities New York, Lynbrook Operations 2026 Consumer Confidence Report (2025 data; hardness, corrosivity index, iron allowance and sodium silicate, caustic soda and lime); U.S. Census Bureau, ACS 2024 5-year (B25040) and B25010, B25041 from the Census Bureau summary file.