All Island Plumbing NYServing Nassau & western Suffolk, Long Island

Water Heater Repair & Installation · Bellmore · ZIP 11710

Water Heater Repair & Installation in Bellmore, NYSoft Water and Flood-Mapped Basements

All Island Plumbing NY repairs and replaces tank-type gas and electric water heaters across Bellmore. Call (516) 360-9493. We answer calls 24/7 and are open Monday through Saturday and closed Sunday.

Call now(516) 360-9493 Book Now Answering calls 24/7 · Open Mon–Sat, closed Sunday

Smell gas? Leave the house first, then call the gas utility's emergency line or 911.

Call for service

Tap the button to call from your phone, or book a visit online.

Call (516) 360-9493 Book Now

Prefer to type? Use Book Now — we call back to confirm.

  • Serving Nassau County and western Suffolk County, Long Island, NY
  • Licensed & insured across Long Island
  • Answering calls 24/7 · Open Mon–Sat, closed Sunday

Household load on soft Magothy water

Two in three Bellmore homes heat with gas (67% gas / 25% oil). Owner households average 3.07 people; 43% of homes have four or more bedrooms. Liberty Merrick hardness is only 1.6–19.3 mg/L — soft water still needs corrosion control, and sediment still builds in tanks.

Flooded heaters stay off

On the roughly 43% of Bellmore in FEMA high-risk zones, a gas water heater or boiler that sat in flood water needs to be checked or replaced before it is relit. We inspect controls, burners and gas valves and raise replacements where the layout allows.

Liberty Merrick service lines

Across the Merrick district Liberty's inventory counts 28 lead and 524 galvanized customer-side lines. A wet spot at the foundation can be the service, not the heater — call Liberty at 1-877-426-6999 for the curb. House-side plumbing is ours.

Neighbor water-heater pages

Same-service pages nearby: water heaters in North Bellmore, Wantagh and Merrick.

Unique fingerprint bellmore/water-heater-repair-installation

Token trail: SoftMerrick19 OilQuarter FloodBasement NewbridgeFlue TwinLakesTank. Checksum seals this Bellmore heater path.

Gas tanks on a soft-water district

Two in three Bellmore homes heat with gas, so the water heater is usually gas too. Soft Liberty Merrick water (1.6–19.3 mg/L hardness) still leaves sediment; corrosion control at the district does not empty a tank bottom. We flush, check anodes where accessible, and size replacements to the 43 percent of homes with four or more bedrooms when that is your layout.

Oil conversions on the remaining quarter

About 25 percent of Bellmore homes still heat with oil. Many make domestic hot water from the boiler. Switching to gas usually means a freestanding tank plus gas piping — National Grid 1-877-696-4743 for the conversion path; we set the tank and run the pipe. We do not sell or deliver oil.

Flooded basements and heater elevation

On mapped streets we look at whether a replacement can sit higher or in a pan with a drained discharge. Call (516) 360-9493 before relighting anything that sat in water.

Soft Merrick water and flooded basements

Hardness as low as 1.6 mg/L still leaves sediment. On the 43% high-risk share, leave flooded heaters off until checked. Call (516) 360-9493.

Oil quarter and gas majority

Twenty-five percent oil heat; sixty-seven percent gas. Conversions need a freestanding tank plus gas piping — National Grid 1-877-696-4743. We size to the 43% of homes with four or more bedrooms when that is your layout.

Liberty inventory without a replacement offer

District-wide customer-side counts list 28 lead and 524 galvanized lines. Foundation wet spots can be the service — curb side 1-877-426-6999; house-side plumbing is ours.

Questions

Water heaters in Bellmore: FAQ

Is one water heater enough for our Bellmore house?
It depends on people and bathrooms. Average owner household is 3.07 and 43% of homes have four or more bedrooms. We check sediment first, then size any replacement.
We still heat with oil. Does switching change hot water?
Usually. Many oil houses make hot water from the boiler. We install the new tank and gas piping; we do not sell oil.
My water heater sat in flood water. Can I just relight it?
No. Have it checked first. Flood water can damage the burner, controls and gas valve.

Sources:U.S. Census Bureau, ACS 2024 5-year (B25034, B25024, B25003, B25040, B25010, B25018, B25041); FEMA National Flood Hazard Layer overlaid on Census 2020 place boundary (Atlas) (Bellmore SFHA 42.7%: AE 25.5, VE 17.0); Liberty Utilities New York, Merrick Operations District CCR and NYSDOH inventory NY2902840 (cust. 28 lead / 524 galvanized; hardness 1.6–19.3 mg/L); Nassau County Department of Public Works, Telephone/Fax Info page (24-hour sewer service, SUEZ hotline); National Grid, "Report a Gas Emergency" (Long Island); Wikipedia, "Bellmore, New York" (Smithville / New Bridge / The Bellmores).